Sierra S5020 Technical Information PDF herunterladen (Seite 54)

Maintenance

Common System Messages

Below is an explanation of the common messages your keypad

might display. Beside each message is a discussion of what re-

sponses are appropriate. If you find the response is ineffective,

call your local C&K service representative.

In the table below, the ellipses (...) represent the specific informa-

tion, such as zone numbers that appear in the numeric display.

If you notice That means What to do:

Power LED is off Keypad is not Verify that the rest of the

receiving AC building is receiving power;

(house current) power then call for service.

That

Display reads: A sensor needs Bypass the sensor, or

"TROUBLE..." service arrange for repair.

Display reads: A sensor may have Call for service.

"TAMPER ..." been tampered with

Display often A sensor may need Call for service.

reads: "TROUBLE...." service

or "TAMPER..."

Display reads: Any one of your Depending upon your

"NOT READY" sensors may be arming type, your system

faulted may be able to arm. If not,

correct any faulted zones

and then attempt to arm.

Display reads An alarm occurred Refer to "Resetting After an

"ALARM..." Alarm" Section 4.

Display reads A zone has been Remember the zone is

"BYPASS..." bypassed unprotected while bypassed.

You can remove the bypass

(Section 3), or arm/disarm

with bypass in place.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 67 68

Keine Kommentare

Sierra S5020 Technical Information Seite 54